DTF MagicSeal Finishing Sheet - 12 x 17 inches - seal Direct to Film Transfer Prints into the Fibers of the Fabric up to 500 times enlarged

DTF MagicSeal Finishing Sheet - 12 x 17 inches - seal Direct to Film Transfer Prints into the Fibers of the Fabric up to 500 times - magicsealcomparison1.png

DTF MagicSeal Finishing Sheet - 12 x 17 inches - seal Direct to Film Transfer Prints into the Fibers of the Fabric up to 500 times

$40
$35.00

Post press your DTF transfer onto a shirt or textile to boost the long life of your textile transfers with our revolutionary DTF MagicSeal. It has been designed to integrate DTF transfer onto any fabric seamlessly!

DTF MagicSeal has special silicon rubber film coating that locks the transfer into the fibers of the shirt, making sure the design stays vivid and in one piece wash after wash. No more peeling, fading - everlasting beauty for you.

DTF MagicSeal is REUSABLE up to 500 presses.

Size: A3 - 12" x 17"

Fabric before and after DTF MagicSeal application

Instructions:

Before the first use, press the sheet with the rubber side down on the lower platen of your heat press with media pressure for 20 seconds at 270° F / 132° C. This will condition the MagicSeal properly.
Press and peel your DTF transfer.
For the final post press, apply the rubbery side of the MagicSeal onto your garment and press for 20 seconds with heavy pressure at a temperature between 270°F - 290°F / 132°C - 143°C.

Note: Use the MagicSeal in place of kraft paper for the final post press only.

CAUTION: WORK IN A WELL VENTILATED AREA and wear PROTECTIVE GEAR (including masks and gloves) while handling specialty printing and curing materials and techniques (such as DTF, DTG, UV, WTT, etc.), due to the potential hazards from fumes and processes. It's strongly advised to use a fume extractor in addition to maintaining proper ventilation when using DTF powder.
Operating any specialty ink printing devices and materials, including inks, chemicals, powders, etc., is entirely at the user's risk.
To reduce the chances of ink clogs and film warping, it is strongly advised to maintain a room humidity 55%-75% and a temperature 75°-80°F / 24°-27°C.

Click here to learn what is DTF and understand its advantages over other garment printing methods.

Images:

Additional Product Images - magicseal-animated.gif