DTG PRO | DTF PRO University Workshop

This personalized training workshop is designed to equip you with broad knowledge for launching DTG (Direct to Garment) or DTF (Direct to Film) printing. If you've acquired one of our DTG or DTF machines, you'll receive tailored instruction. The training covers printer setup, RIP software use, and maintenance procedures. We'll share valuable insights and techniques honed through years of experience to ensure you achieve the best quality prints and extend the lifespan of your equipment.

Our workshop typically run for a maximum of 2 hours, allowing for focused attention. In most cases, a single 1-hour session enough to fully set up and operate DTG or DTF printing. However, with this purchase, you have the luxury of a full 2-hour window, which can be divided into multiple sessions of at least 30 minutes each, as per your convenience.

After purchasing this training, we'll coordinate with you to schedule a suitable time. Please note that this training is non-transferable and is limited to the individual who placed the order. If you sell the printer or hire new employees requiring training, additional training sessions must be purchased. Additionally, this purchase can also serve as a means to access out-of-warranty support.