DTF PRO XTREME Cleaning Solution Concentrate - DTF, DTG Printhead Cleaner

$100
$54.00

Out of Stock

950ml XTREME Printhead Cleaning Solution Concentrate - mix in ratio 1:4 with distilled water to yield 1 gallon.

DTF PRO XTREME Printhead Cleaning Solution is intended for flushing ink tubing or unclogging stubborn printhead clogs. It is specifically designed to address extreme or stubborn clogs and can also be used to flush out inks from the ink tubing if you need to change them. If you have a damper/CIS based system, you can flush your printheads with this solution. Alternatively, if you have a cartridge-based system, you can fill the solution into cleaning cartridges and run up to three cleaning cycles with those cartridges. However, it is important to note that this solution should not be used for wet capping.

CAUTION: WORK IN A WELL VENTILATED AREA and wear PROTECTIVE GEAR (including masks and gloves) while handling specialty printing and curing materials and techniques (such as DTF, DTG, UV, WTT, etc.), due to the potential hazards from fumes and processes. It's strongly advised to use a fume extractor in addition to maintaining proper ventilation when using DTF powder.
Operating any specialty ink printing devices and materials, including inks, chemicals, powders, etc., is entirely at the user's risk.
To reduce the chances of ink clogs and film warping, maintain the environment for specialty inks and films within optimal humidity (50% - 70%) and temperature (75° to 80°F) conditions. To reduce the likelihood of ink clogs and prevent film buckling, it is strongly advised to maintain a room humidity 50%-70% and a temperature 75°-80°F / 24°-27°C.